Command Reference Guide

Router (OSPF) Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 907
auto-cost reference-bandwidth <rate>
Use the auto-cost reference-bandwidth command to assign a different interface cost to an interface. It
may be necessary to assign a higher number to high-bandwidth links
. This value is used in OSPF metric
calculations.
Syntax Description
<rate> Set the default reference-bandwidth rate (range: 1-4294967 Mbps).
Default Values
By default, the rate is set to 100.
Command Modes
(config-ospf)# Router (OSPF) Configuration Mode required
Usage Examples
The following example sets the auto cost reference-bandwidth to 1000 Mbps:
(config)#router ospf
(config-ospf)#auto-cost reference-bandwidth 1000