Command Reference Guide

Router (RIP) Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 902
version <version>
Use the version command to specify (globally) the Routing Information Protocol (RIP) version used on all
IP interfaces. This global configuration is overridden using the configuration commands ip rip send
version and ip rip receive version. Use the no form of this command to return to the default value.
Syntax Description
<version> Specifies the RIP version used globally
1 RIP version 1
2 RIP version 2
Default Values
By default, RIP is not enabled.
Command Modes
(config-rip)# Router (RIP) Configuration Mode required
Usage Examples
The following example specifies RIP version 2 as the global RIP version:
(config)#router rip
(config-rip)#version 2