Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set

debug port-auth [general | packet [both | rx | tx] | supp-sm]

Use the debug port-auth command to generate debug messages used to aid in troubleshooting problems

during the port authentication process. Use the no version of this command to disable the messages.

Syntax Description

general Optional. Displays configuration changes to the port authentication system.

packet Optional. Displays information for packet exchange in transmit-only, receive-only

or both directions.

both Optional. Displays packet exchange information in both receive and transmit

directions.

rx Optional. Displays packet exchange information in the receive-only direction.

tx Optional. Displays packet exchange information in the transmit-only direction.

supp-sm Optional. Displays information pertaining to the supplicant state machine.

Default Values

By default, all debug messages in the Secure Router OS are disabled.

Command Modes

# Enable Command Mode

Usage Examples

The following example activates port authentication debug information on received packets:

>enable

#debug port-auth packet rx

Received EAPOL Start for session 1 on interface eth 0/2