Command Reference Guide

Router (RIP) Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 894
ROUTER (RIP) CONFIGURATION COMMAND SET
To activate the Router (RIP) Configuration , enter the router rip command at the Global Configuration
Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# router rip
Router(config-rip)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
All other commands for this command set are described in this section in alphabetical order.
auto-summary on page 895
default-metric <value> on page 896
network <address> <subnet mask> on page 897
passive-interface <interface> on page 898
redistribute connected [metric <value>] on page 899
redistribute ospf [metric <value>] on page 900
redistribute static [metric <value>] on page 901
version <version> on page 902