Command Reference Guide

Line (Telnet) Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 887
LINE (TELNET) INTERFACE CONFIG COMMAND SET
To activate the Line (Telnet) Interface Configuration , enter the line telnet command specifying a Telnet
session(s) at the Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# line telnet 0 4
Router(config-telnet0-4)#
You can select a single line by entering the line telnet command followed by the line number (0-4). For
example:
Router>
enable
Router# configure terminal
Router(config)# line telnet 2
Router(config-telnet2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 928
end on page 929
exit on page 930
All other commands for this command set are described in this section in alphabetical order.
access-class <listname> in on page 888
line-timeout <minutes> on page 889
login on page 890
login authentication <aaa login list> on page 891
login local-userlist on page 892
password [md5] <password> on page 893