Command Reference Guide

SROS Command Line Interface Reference Guide Line (Console) Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 876
LINE (CONSOLE) INTERFACE CONFIG COMMAND SET
To activate the Line (Console) Interface Configuration , enter the line console 0 command at the Global
Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# line console 0
Router(config-con 0)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
All other commands for this command set are described in this section in alphabetical order.
databits <option> on page 877
flowcontrol [none | software in] on page 878
line-timeout <minutes> on page 879
login on page 880
login authentication <aaa login list> on page 881
login local-userlist on page 882
parity <option> on page 883
password [md5] <password> on page 884
speed <rate> on page 885
stopbits <option> on page 886