Command Reference Guide

SROS Command Line Interface Reference Guide Loopback Interface Configuration Command Set

ip rip receive version <version>

Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets

received on the interface.

Syntax Description

<version> Specifies the RIP version.

1 Only accept received RIP version 1 packets on the interface.

2 Only accept received RIP version 2 packets on the interface.

Default Values

By default, all interfaces implement RIP version 1 (the default value for the version command).

Command Modes

(config-interface)# Interface Configuration Mode required (applies to all physical interfaces as well as

virtual interfaces)

Functional Notes

Use the ip rip receive version to specify a RIP version that overrides the version (in the Router RIP )

configuration.

The Secure Router OS only accepts one version (either 1 or 2) on a given interface.

Usage Examples

The following example configures the loopback interface to accept only RIP version 2 packets:

(config)#interface loopback 1

(config-loop 1)#ip rip receive version 2