Command Reference Guide

SROS Command Line Interface Reference Guide Loopback Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 851
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value> Enter bandwidth in kbps.’
Default Values
To view default values, use the show interfaces command.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet (eth 0/1), Frame Relay Virtual Sub-interfaces
(fr 1.20), virtual PPP (ppp 1), and loopback interfaces
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the loopback interface to 10 Mbps:
(config)#interface loopback 1
(config-loop 1)#bandwidth 10000