Command Reference Guide

SROS Command Line Interface Reference Guide Loopback Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 847
LOOPBACK INTERFACE CONFIGURATION COMMAND SET
To activate the Loopback Interface Configuration , enter the interface loopback command at the Global
Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface loopback 1
Router(config-loop 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 923
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
shutdown on page 935
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 848
bandwidth <value> on page 851
crypto map <mapname> on page 852
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on
page 855
ip commands begin on page 857
mtu <size> on page 873
snmp trap on page 874
snmp trap link-status on page 875