Command Reference Guide

SROS Command Line Interface Reference Guide HDLC Command Set

lldp receive

Use the lldp receive command to allow LLDP packets to be received on this interface.

Syntax Description

No subcommands.

Default Values

By default, all interfaces are configured to send and receive LLDP packets.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual

HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Usage Examples

The following example configures the HDLC interface to receive LLDP packets:

(config)#interface hdlc 1

(config-hdlc 1)#lldp receive