Command Reference Guide

SROS Command Line Interface Reference Guide HDLC Command Set

ip rip receive version [1 | 2]

Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets

received on the interface. Use the no form of this command to restore the default value.

Syntax Description

Only accept received RIP version 1 packets on the interface.

Only accept received RIP version 2 packets on the interface.

Default Values

By default, all interfaces implement RIP version 1 (the default value for the version command).

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual

HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

Use the ip rip receive version command to specify a RIP version that overrides the version (in the

Router RIP) configuration. See

version <version> on page 902 for more information.

The SROS only accepts one version (either 1 or 2) on a given interface.

Usage Examples

The following example configures the HDLC interface to accept only RIP version 2 packets:

(config)#interface hdlc 1

(config-hdlc 1)#ip rip receive version 2