Command Reference Guide

SROS Command Line Interface Reference Guide HDLC Command Set

HDLC COMMAND SET

To activate the HDLC mode, enter the interface hdcl command at the Global Configuration mode prompt.

For example:

>enable

configure terminal

(config)#interface hdlc 1

(config-hdlc 1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 813

bandwidth <value> on page 816

bridge-group <group#> on page 817

crypto map <mapname> on page 818

dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on

page 820

fair-queue <threshold> on page 822

hold-queue <queue size> out on page 823

ip commands begin on page 824

keepalive <seconds> on page 841

lldp receive on page 842

lldp send [management-address l port-description l system-capabilities l system-description l

system-name l and-receive] on page 843