Command Reference Guide

Command Reference Guide Tunnel Configuration Command Set

ip rip receive version [1 | 2]

Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets

received on the interface. Use the no form of this command to restore the default value.

Syntax Description

Only accept received RIP version 1 packets on the interface.

Only accept received RIP version 2 packets on the interface.

Default Values

By default, all interfaces implement RIP version 1 (the default value for the version command).

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC

virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

Use the ip rip receive version command to specify a RIP version that overrides the version (in the

Router RIP) configuration. See

version <version> on page 902 for more information.

The SROS only accepts one version (either 1 or 2) on a given interface.

Usage Examples

The following example configures the tunnel interface to accept only RIP version 2 packets:

(config)#interface tunnel 1

(config-tunnel 1)#ip rip receive version 2