Command Reference Guide

Command Reference Guide Tunnel Configuration Command Set

TUNNEL CONFIGURATION COMMAND SET

To activate the Tunnel Configuration mode, enter the interface tunnel command at the Global

Configuration mode prompt. For example:

Router>enable

Router#

configure terminal

Router(config)#

interface tunnel 1

Router(config-tunnel 1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 779

bandwidth on page 782

dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on

page 783

ip commands begin on page 786

keepalive <period> <retries> on page 803

tunnel commands begin on page 804