Command Reference Guide

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

ppp multilink

Use the ppp multilink command to enable multilink PPP (MPPP) operation. Use the no form of this

command to disable.

Syntax Description

No subcommands.

Default Values

By default, MPPP is disabled.

Command Modes

(config-ppp 1)# PPP Interface Configuration Mode

Functional Notes

When enabled, this interface is capable of the following:

• Combining multiple physical links into one logical link.

• Receiving upper layer protocol data units (PDU), fragmenting and transmitting over the physical links

based upon the physical link MTU.

• Receiving fragments over the physical links and reassembling them into PDUs.

Usage Examples

The following example enables MPPP:

(config-ppp 1)#ppp multilink