Command Reference Guide

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

bind <#> <from interface> <slot/port> <tdm-group#> <to interface>

Use the bind command to create a bind map from a created tdm-group on an interface to a virtual interface.

Syntax Description

<#> Number descriptor or label for identifying the bind (useful in systems that allow

multiple binds)

<from interface> Specifies the interface (physical of virtual) on one end of the bind

Valid interfaces include: Ethernet (eth 0/1), T1 (t1 1/1), DDS (dds 1/1), serial (ser

1/1), and shdsl (shdsl 1/1)

<slot/port> Used when a physical interface is specified in the <from interface> subcommand

(For example: specifying the T1 port of a T1 module would be t1 1/1).

<tdm-group#> Specifies which configured tdm-group to use for this bind. This subcommand only

applies to T1 physical interfaces.

<to interface> Specifies the virtual interface on the other end of the bind.

<slot/port> Used when a physical interface is specified in the <to interface> subcommand.

(For example, specifying the primary T1 port of a T1 module would be t1 1/1).

Default Values

By default, there are no configured binds.

Command Modes

(config)# Global Configuration Mode

(config-ppp 1)# PPP Interface Configuration Mode

Functional Notes

Binds provide the mechanism for connecting a configured virtual (layer 2) endpoint with a physical (layer 1)

interface. Supported layer 2 protocols include Frame Relay and point-to-point protocol (PPP).

Caution

Changing bind settings could potentially result in service interruption.