Command Reference Guide

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

PPP INTERFACE CONFIGURATION COMMAND SET

To activate the PPP Interface Configuration , enter the interface ppp command at the Global

Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface ppp 1

Router(config-ppp 1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 717

alias link<“text”> on page 720

bandwidth <value> on page 721

bridge-group commands begin on page 725

crypto map <mapname> on page 731

backup commands begin on page 733

dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on

page 742

fair-queue <threshold> on page 744

hold-queue <queue size> out on page 745

ip commands begin on page 746

keepalive <seconds> on page 763