Manualshelf

Command Reference Guide

ManualsBrandsHP ManualsRoutersHP 7000 dl Router Series
711712713714715716717718719720
SROS Command Line Interface Reference Guide BGP Neighbor Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 711
BGP NEIGHBOR CONFIGURATION COMMAND SET
To activate the BGP Neighbor Configuration, enter the bgp-neighbor command at the Global
Configuration Mode prompt. For example:
Switch>
enable
Switch#
configure terminal
Switch(config)#bgp-neighbor
Switch(config-bgp-neighbor)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
exit on page 930
All other commands for this command set are described in this section in alphabetical order.
advertisement-interval <seconds> on page 712
ebgp-multihop <hop count> on page 713
hold-timer <hold time> on page 714