Command Reference Guide

SROS Command Line Interface Reference Guide BGP Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 705
BGP CONFIGURATION COMMAND SET
To activate the BGP Configuration, enter the bgp command at the Global Configuration Mode prompt. For
example:
Switch>
enable
Switch# configure terminal
Switch(config)#bgp
Switch(config-bgp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
description on page 927
exit on page 930
All other commands for this command set are described in this section in alphabetical order.
bgp fast-external-fallover on page 706
bgp log-neighbor-changes on page 707
bgp router-id <ip address> on page 708
distance bgp <external> <internal> <local> on page 709
hold-timer <hold time> on page 710