Command Reference Guide

SROS Command Line Interface Reference Guide ADSL Interface Config Command Set

ADSL INTERFACE CONFIG COMMAND SET

To activate the ADSL Interface Configuration , enter the interface adsl command at the Global

Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface adsl 0/1

Router(config-adsl 0/1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

retrain on page 702

snr-margin [showtime monitor | training monitor] <margin> on page 703

training-mode [G.DMT | G.LITE | Multi-Mode | T1.413] on page 704