Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 696
spanning-tree bpduguard [enable | disable]
Use the spanning-tree bpduguard command to block BPDUs from being received on this interface. To
return to the default value, use the no form of this command.
Syntax Description
enable Enable the BPDU block.
disable Disable the BPDU block.
Default Values
By default, this command is set to disable.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: ATM sub-interface, Ethernet, virtual PPP interfaces, and
virtual Frame Relay sub-interfaces
Usage Examples
The following example enables the bpduguard on the interface:
(config)#interface atm 1.1
(config-atm 1.1)#spanning-tree bpduguard enable