Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 694
qos-policy out <mapname>
Use the qos-policy out command to apply a previously-configured QoS map to an interface. Use the no
form of this command to remove the map from the interface. The out keyword specifies that this policy
will be applied to outgoing packets.
Syntax Description
<map name> Enter the name of a previously-created QoS map (see qos map
<mapname><sequence number>
on page 326 for more information).
Default Values
No default value is necessary for this command.
Command Modes
(config-interface)# Interface Configuration Mode. Valid interfaces include: ATM sub-interface, virtual
PPP, and virtual Frame Relay interfaces .
Usage Examples
The following example applies the QoS map VOICEMAP to the ATM sub-interface 1.1:
(config)#interface atm 1.1 1
(config-atm 1.1)#qos-policy out VOICEMAP