Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 687
ip rip send version <version>
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface. Use the no form of this command to restore the default value.
Syntax Description
<version> Specifies the RIP version
1 Only transmits RIP version 1 packets on the interface
2 Only transmits RIP version 2 packets on the interface
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command)
Command Modes
(config-interface)# Interface Configuration Mode required
Functional Notes
Use the ip rip send version to specify a RIP version that will override the version (in the Router RIP )
configuration.
The Secure Router OS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the ATM sub-interface 1.1 to transmit only RIP version 2 packets:
(config)#interface atm 1.1
(config-atm 1.1)#ip rip send version 2