Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 683
ip ospf authentication [message-digest | null]
Use the ip ospf authentication command to authenticate an interface that is performing OSPF
authentication.
Syntax Description
message-digest Select message-digest authentication type.
null Select for no authentication to be used.
Default Values
By default, this is set to null (meaning no authentication is used).
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: ATM sub-interface, Ethernet, virtual PPP interfaces,
virtual Frame Relay sub-interfaces, and loopback interfaces
Usage Examples
The following example specifies that no authentication will be used on the ATM sub-interface 1.1:
(config-atm 1.1)#ip ospf authentication null