Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set

debug dialup-interfaces

Use the debug dialup-interfaces command to generate debug messages used to aid in troubleshooting

problems with all dialup interfaces such as the modem or the BRI cards. Use the no version of this

command to disable it.

Syntax Description

No subcommands.

Default Values

By default, all debug messages in the Secure Router OS are disabled.

Command Modes

# Enable Command Mode

Functional Notes

When enabled, these messages provide status information on incoming calls, dialing and answering

progress, etc. These messages also give information on why certain calls are dropped or rejected. It is

beneficial to use this command when troubleshooting backup (in addition to the debug backup

command).

Usage Examples

The following example activates the debug messages for dialup interfaces:

>enable

#debug dialup-interfaces