Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 666
encapsulation [aal5mux | aal5snap]
Use the encapsulation command to configure the encapsulation type for the ATM adaption Layer (AAL)
of the ATM Protocol Reference Model.
Variations of this command include the following:
encapsulation aal5mux [ip | ppp]
encapsulation aal5snap
Syntax Description
aal5mux Encapsulation type for multiplexed virtual circuits. A protocol must be specified.
aal5snap Encapsulation type that supports LLC/SNAP protocols.
[ip | ppp] Protocol type used for multiplexed virtual circuits (aal5mux).
Default Values
By default, the encapsulation type is aal5snap.
Command Modes
(config-atm 1.1)# ATM Sub-Interface Configuration Mode required
Functional Notes
For PPP and PPoE, the encapsulation type can be aal5snap or aal5mux ppp.
For IP with no bridging, the encapsulation type can be aal5snap or aal5mux ip.
For IP with bridging, the encapsulation type can only be aal5snap
For bridging, the encapsualtion type can only be aal5snap.
Usage Examples
The following example sets the encapsulation type to all5snap:
(config-atm 1.1)#encapsulation aal5snap