Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 649
atm routed-bridged [ip]
Use the atm routed-bridged ip command to enable routed bridge encapsulation (RBE) on an interface.
Use the no form of this command to disable RBE operation.
Syntax Description>
ip Use ip protocol to be route bridged.
Default Values
By default, routed bridge encapsulation is disabled.
Command Modes
(config-atm 1.1)# ATM Sub-Interface Configuration Mode required
Usage Examples
The following example enables routed bridge encapsulation:
(config)#interface atm 1.1
(config-atm 1.1)#atm routed-bridged ip