Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set

access-policy <policyname>

Use the access-policy command to assign a specified access policy for the inbound traffic on an interface.

Use the no form of this command to remove an access policy association.

Syntax Description

<policyname> Alphanumeric descriptor for identifying the configured access policy (all access

policy descriptors are case-sensitive)

Default Values

By default, there are no configured access policies associated with an interface.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: ATM sub-interface, Ethernet, PPP virtual interfaces,

Frame Relay virtual sub-interfaces, and VLAN interface.

Functional Notes

To assign an access policy to an interface, enter the Interface Configuration Mode for the desired interface

and enter access policy <policy name>.

Note

Configured access policies will only be active if the ip firewall command has been entered

at the Global Configuration Mode prompt to enable the Secure Router OS security features.

All configuration parameters are valid, but no security data processing will be attempted

unless the security features are enabled.