Command Reference Guide

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 647
ATM SUB-INTERFACE CONFIG COMMAND SET
To activate the ATM Interface Configuration , enter the interface atm command (and specify a sub-interface) at
the Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface atm 1.1
Router(config-atm 1.1)#
The following commands are common to multiple command sets and are covered in a centralized section of this
guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
exit on page 930
ping <address> on page 931
show running-config on page 933
shutdown on page 935
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 648
atm routed-bridged [ip] on page 649
backup commands begin on page 652
bandwidth <value> on page 660
bridge-group <group#> on page 661
crypto map <mapname> on page 662
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on page 664
encapsulation [aal5mux | aal5snap] on page 666
fair-queue <threshold> on page 667
hold-queue <queue size> out on page 668
ip commands begin on page 669
mtu <size> on page 690
oam commands begin on page 691
pvc <VPI/VCI> on page 693
qos-policy out <mapname> on page 694
spanning-tree commands begin on page 696