Command Reference Guide

SROS Command Line Interface Reference Guide ATM Interface Config Command Set

ATM INTERFACE CONFIG COMMAND SET

To activate the ATM Interface Configuration , enter the interface atm command at the Global

Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface atm 1

Router(config-atm 1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

snmp trap on page 645

snmp trap link-status on page 646