Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

ip rip send version <version>

Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets

transmitted on the interface. Use the no form of this command to restore the default value.

Syntax Description

<version> Specifies the RIP version

1 Only transmits RIP version 1 packets on the interface

2 Only transmits RIP version 2 packets on the interface

Default Values

By default, all interfaces transmit RIP version 1 (the default value for the version command)

Command Modes

(config-interface)# Interface Configuration Mode required (applies to all physical interfaces as well as

virtual interfaces)

Functional Notes

Use the ip rip send version to specify a RIP version that will override the version (in the Router RIP )

configuration.

The Secure Router OS only transmits one version (either 1 or 2) on a given interface.

Usage Examples

The following example configures a Frame Relay sub-interface to transmit only RIP version 2 packets:

(config)#interface frame-relay 1.16

(config-fr 1.16)#ip rip send version 2