Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

ip rip receive version <version>

Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets

received on the interface. Use the no form of this command to restore the default value.

Syntax Description

<version> Specifies the RIP version

1 Only accept received RIP version 1 packets on the interface

2 Only accept received RIP version 2 packets on the interface

Default Values

By default, all interfaces implement RIP version 1 (the default value for the version command).

Command Modes

(config-interface)# Interface Configuration Mode required (applies to all physical interfaces as well as

virtual interfaces)

Functional Notes

Use the ip rip receive version to specify a RIP version that will override the version (in the Router RIP )

configuration.

The Secure Router OS only accepts one version (either 1 or 2) on a given interface.

Usage Examples

The following example configures a Frame Relay sub-interface to accept only RIP version 2 packets:

(config)#interface frame-relay 1.16

(config-fr 1.16)#ip rip receive version 2