Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

ip proxy-arp

Use the ip proxy-arp to enable proxy Address Resolution Protocol (ARP) on the interface. Use the no

form of this command to disable this feature.

Syntax Description

<address> Defines the IP address for the interface in dotted decimal notation (for example:

192.22.73.101)

<subnet mask> Specifies the subnet mask that corresponds to the listed IP address

Default Values

By default, proxy arp is enabled.

Command Modes

(config-interface)# Interface Configuration Mode required (applies to all physical interfaces as well as

virtual interfaces)

Functional Notes

In general, the principle of proxy-arp allows a router to insert its IP address in the source IP address field of

a packet (if the packet is from a host on one of its subnetworks). This allows hosts to reach devices on

other subnetworks without implementing routing or specifying a default gateway.

If proxy-arp is enabled, the Secure Router OS will respond to all proxy-arp requests with its specified MAC

address and forward packets accordingly.

Enabling proxy-arp on an interface may introduce unnecessary ARP traffic on the network.

Usage Examples

The following enables proxy-arp on the Frame Relay sub-interface:

(config)#interface frame-relay 1.16

(config-fr 1.16)#ip proxy-arp