Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 616
frame-relay interface-dlci <dlci>
Use the frame-relay interface-dlci command to configure the Data Link Connection Identifier (DLCI) for
the Frame Relay sub-interface. This setting should match the DLCI supplied by your Frame Relay service
provider. Use the no form of this command to remove the configured DLCI.
Syntax Description
<dlci> Enter numeric value supplied by your provider
Default Values
<dlci> The default DLCI is populated with the sub-interface identifier. For example, if
configuring the virtual Frame Relay sub-interface labeled fr 1.20 , the default DLCI
is 20.
Command Modes
(config-fr 1.1)# Virtual Frame Relay Sub-Interface Configuration Mode required
Usage Examples
The following example configures a DLCI of 72 for this Frame Relay endpoint:
(config)#interface fr 1.16
(config-fr 1.16)#frame-relay interface-dlci 72