Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

backup connect-timeout <seconds>

Use the backup connect-timeout command to specify the number of seconds to wait for a connection

after a call is attempted before trying to call again or dialing a different number. It is recommended this

number be greater than 60.

Syntax Description

<seconds> Selects the amount of time in seconds that the router will wait for a connection

before attempting another call (valid range: 10 to 300)

Default Values

<seconds> 60 seconds

Command Modes

(config-fr 1.16)# Virtual Frame Relay Sub-Interface Configuration Mode

(config-atm 1.1)# ATM Sub-Interface Configuration Mode

Usage Examples

The following configures the Secure Router OS to wait 120 seconds before retrying a failed backup call:

(config)#interface atm 1.1

(config-atm 1.1)#backup connect-timeout 120