Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 591
backup auto-backup
Use the backup auto-backup command to configure the sub-interface to automatically attempt a backup
upon failure.
Syntax Description
No subcommands.
Default Values
By default, all backup endpoints will automatically attempt backup upon a failure.
Command Modes
(config-fr 1.16)# Virtual Frame Relay Sub-Interface Configuration Mode
(config-atm 1.1)# ATM Sub-Interface Configuration Mode
Usage Examples
The following enables automatic backup on the endpoint:
(config)#interface atm 1.1
(config-atm 1.1)#backup auto-backup