Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 587
FRAME RELAY SUB-INTERFACE CONFIG COMMAND SET
To activate the Frame Relay Interface Configuration , enter the interface frame-relay command (and
specify a sub-interface) at the Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface frame-relay 1 . 16
Router(config-fr 1.16)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 588
backup commands begin on page 591
bandwidth <value> on page 599
bridge-group <group#> on page 600
crypto map <mapname> on page 601
backup commands begin on page 591
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on
page 611
ip commands begin on page 617
mtu <size> on page 637
spanning-tree commands begin on page 638