Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 586
snmp trap link-status
Use the snmp trap link-status command to control the SNMP variable ifLinkUpDownTrapEnable (RFC
2863), which enables (or disables) the interface to send SNMP traps when there is an interface status
change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay
interfaces.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet (eth 0/1), VLAN, T1 (t1 1/1), E1 (e1 1/1), DSX-1
(t1 1/2), G.703, serial (ser 1/1), DDS (dds 1/1), virtual Frame Relay (fr 1), virtual
PPP (ppp 1), SHDSL (shdsl 1/1), and loopback interfaces.
Functional Notes
The snmp trap link-status command is used to control the RFC 2863 ifLinkUpDownTrapEnable OID (OID
number 1.3.6.1.2.1.31.1.1.1.14.0).
Usage Examples
The following example disables the link-status trap on the Frame Relay interface:
(config)#interface frame-relay 1
(config-fr 1)#no snmp trap link-status