Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 585
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet (eth 0/1), Ethernet sub-interfaces (eth 0/1.1),
VLAN, DDS (dds 1/1), serial (ser 1/1), virtual Frame Relay (fr 1), and SHDSL
(shdsl 1/1) interfaces.
Usage Examples
The following example enables SNMP on the virtual Frame Relay interface:
(config)#interface frame-relay 1
(config-fr 1)#snmp trap