Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 577
frame-relay lmi-n393dte <counter>
Use the frame-relay lmi-n393dte command to set the N393 LMI monitored event counter for the DTE
endpoint. Typical applications should leave the default value for this counter. Use the no form of this
command to return to the default value.
Syntax Description
<counter> Sets the counter value (valid range: 1-10)
Default Values
<counter> 4 events
Command Modes
(config-fr 1)# Virtual Frame Relay Interface Configuration Mode required
Usage Examples
The following example sets the N393 threshold for 5 events:
(config)#interface frame-relay 1
(config-fr 1)#frame-relay lmi-n393dte 5