Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 571
frame-relay intf-type <type>
Use the frame-relay intf-type command to define the Frame Relay signaling role needed for the endpoint.
Use the no form of this command to return to the default value.
Syntax Description
<type> Specifies the Frame Relay interface types as DTE, DCE, or NNI
dce DCE or Network signaling role. Use this interface type when you need the unit to
emulate the frame switch.
dte DTE or User signaling role. Use this interface type when connecting to a Frame
Relay switch (or piece of equipment emulating a frame switch).
nni Configures the interface to support both network and user signaling (DTE or DCE)
when necessary.
Default Values
<type> dte
Command Modes
(config-fr 1)# Virtual Frame Relay Interface Configuration Mode required
Usage Examples
The following example configures the Frame Relay endpoint for DCE signaling:
(config)#interface frame-relay 1
(config-fr 1)#frame-relay intf-type dce