Command Reference Guide

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 567
FRAME RELAY INTERFACE CONFIG COMMAND SET
To activate the Frame Relay Interface Configuration , enter the interface frame-relay command at the
Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface frame-relay 1
Router(config-fr 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 923
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
shutdown on page 935
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value> on page 568
encapsulation frame-relay ietf on page 569
fair-queue <threshold> on page 570
frame-relay commands begin on page 571
hold-queue <queue size> out on page 583
qos-policy out <mapname> on page 584
snmp trap on page 585
snmp trap link-status on page 586