Command Reference Guide

SROS Command Line Interface Reference Guide BRI Interface Configuration Command set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 562
bonding txnull-timer <seconds>
Use the bonding txnull-timer command to specify the value (in seconds) for the answering endpoint
negotiation timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds> Specifies the number of seconds the endpoint waits to detect the BONDING
negotiation frame pattern from the originating endpoint (after answering a call)
before considering the BONDING negotiation a failure
Default Values
<seconds> 10 seconds
Command Modes
(config-bri 1/2)# BRI Interface Configuration Mode required
Functional Notes
Specifies the length of time the answering endpoint attempts to detect the BONDING negotiation pattern
from the originating endpoint before deciding the BONDING call has failed. It may be necessary to shorten
this timer if the DTE equipment using the BONDING module also has timer constraints for completing
non-BONDING parameter negotiation.
Usage Examples
The following example defines a txnull-timer value of 8 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txnull-timer 8