Command Reference Guide

SROS Command Line Interface Reference Guide BRI Interface Configuration Command set

bonding txfa-timer <seconds>

Use the bonding txfa-timer command to specify the value (in seconds) for the frame pattern detection

timeout. Use the no form of this command to return to the default value.

Syntax Description

<seconds> Specifies the number of seconds the endpoint allots for attempting to detect the

BONDING frame pattern (when a call is connected) before considering the

BONDING negotiation a failure

Default Values

<seconds> 10 seconds

Command Modes

(config-bri 1/2)# BRI Interface Configuration Mode required

Functional Notes

Specifies the length of time both endpoints attempt to detect the BONDING frame pattern when a call is

connected before deciding the BONDING call has failed. When operating with other manufacturers'

BONDING equipment, it may be necessary to change this time so that it matches TXADD01.

Usage Examples

The following example defines a txfa-timer value of 15 seconds:

(config)#interface bri 1/2

(config-bri 1/2)#bonding txfa-timer 15