Command Reference Guide

SROS Command Line Interface Reference Guide BRI Interface Configuration Command set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 559
bonding txdeq-timer <seconds>
Use the bonding txdeq-timer command to specify the value (in seconds) for the network delay
equalization timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds> Specifies the number of seconds the endpoint allots for attempting to equalize the
network delay between bearer channels before considering the BONDING
negotiation a failure
Default Values
<seconds> 50 seconds
Command Modes
(config-bri 1/2)# BRI Interface Configuration Mode required
Functional Notes
Specifies the length of time both endpoints allot to attempt to equalize the network delay between the
bearer channels before deciding the BONDING call has failed.
Usage Examples
The following example defines a txdeq-timer value of 80 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txdeq-timer 80