Command Reference Guide

SROS Command Line Interface Reference Guide BRI Interface Configuration Command set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 557
bonding txadd-timer <seconds>
Use the bonding txadd-timer command to specify the value (in seconds) for the aggregate call connect
timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds> Specifies the number of seconds the endpoint will wait for additional channels (to
add to the bonded aggregate) before considering the BONDING negotiation a
failure
Default Values
<seconds> 50 seconds
Command Modes
(config-bri 1/2)# BRI Interface Configuration Mode required
Functional Notes
Specifies the length of time both endpoints wait for additional calls to be connected at the end of
negotiation before deciding that the BONDING call has failed. The factory default setting is sufficient for
most calls to connect, although when dialing overseas it may be necessary to lengthen this timer to allow
for slower call routing.
Usage Examples
The following example defines a txadd-timer value of 95 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txadd-timer 95