Command Reference Guide

SROS Command Line Interface Reference Guide BRI Interface Configuration Command set

BRI INTERFACE CONFIGURATION COMMAND SET

To activate the BRI Interface Configuration , enter the interface bri command at the Global Configuration

Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface bri 1/2

Router(config-bri 1/2)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

bonding commands begin on page 557

caller-id override [always <number> | if-no-cid <number>] on page 563

isdn spid1 <spid> <ldn> on page 564

isdn spid2 <spid> <ldn> on page 565

isdn switch-type <type> on page 566

Note

The BRI interface number in the example above is shown as bri 1/2. This number is based

on the interface’s location (slot/port) and could vary depending on the unit’s configuration.

Use the do show interfaces command to determine the appropriate interface number.