Command Reference Guide

SROS Command Line Interface Reference Guide Modem Interface Configuration Command Set

caller-id override [always <number> | if-no-cid <number>]

Use the caller-id override command to configure the unit to replace caller ID information with a

user-specified number. Use the no form of this command to disable any caller ID overrides.

Syntax Description

always <number> Always forces replacement of the incoming caller ID number with the number

given.

if-no-cid <number> Replaces the incoming caller ID number with the number given only if there is no

caller ID information available for the incoming call.

Default Values

By default, this command is disabled.

Command Modes

(config-bri 1/2)# BRI and Modem Interface Configuration Mode required

(config-modem 1/2)# Modem Interface Configuration Mode

Functional Notes

Forces a replacement of the incoming caller ID number with the number given. The received caller ID, if

any, is discarded, and the given override number is used to connect the incoming call to a circuit of the

same number.

Usage Examples

The following example configures the unit to always provide the given number as the caller ID number:

(config)#interface modem 1/2

(config-modem 1/2)#caller-id override always 5555555