Command Reference Guide

SROS Command Line Interface Reference Guide G.703 Interface Configuration Command set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 545
G.703 INTERFACE CONFIGURATION COMMAND SET
To activate the G.703 Interface Configuration , enter the interface e1 command (and specify the G.703
port) at the Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface e1 1/2
Router(config-e1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 923
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
shutdown on page 935
All other commands for this command set are described in this section in alphabetical order.
coding [ami | hdb3] on page 546
framing [crc4] on page 547
loopback network [line | payload] on page 548
snmp trap link-status on page 549
test-pattern [511 l clear l insert l ones | qrss l show 511 l show qrss l zeros] on page 550
ts16 on page 551