Command Reference Guide

SROS Command Line Interface Reference Guide E1 Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 538
remote-loopback
Use the remote-loopback command to configure the interface to accept loopback requests from a remote
unit (or the service provider). Use the no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Values
No default value is necessary for this command.
Command Modes
(config-interface)# Interface configuration mode.
Functional Notes
This controls the acceptance of any remote loopback requests. When enabled, remote loopbacks are
detected and cause a loopback to be applied. When disabled, remote loopbacks are ignored.
Usage Examples
The following example enables remote loopbacks on the E1 interface:
(config)#interface e1 1/1
(config-e1 1/1)#remote-loopback